Accessory Fault Isolator
- Accessory Fault Isolator
Accessory Fault Isolator
A detector mounting base with a built-in line fault isolator for Class A circuits. If a short develops anywhere on the loop, the isolator on either side of the fault opens automatically — keeping the rest of the loop in service.
- Built-in line fault isolator for Class A circuits
- Isolates a short from the rest of the loop within 23 msec
- Self-restoring — no manual reset once the fault clears
- Fits North American and European electrical box standards
- Requires a detector installed to operate
- UL FM Listed
Product Overview
The Kidde KI-IB is a detector mounting base with a built-in line fault isolator, used on Class A fire alarm circuits to stop a single wiring short from taking down an entire loop. A detector head must be installed in the base for the isolator to function — the base does not operate on its own.
When a short occurs, every isolator on the circuit opens within 23 milliseconds. The loop controller then closes isolators one at a time, 10 milliseconds apart, starting from the side nearest the controller, until it reaches the isolator next to the fault — which reopens immediately, sealing off just the faulty section while the rest of the loop keeps reporting normally. This base does not support the GSA-LED remote indicator.
Where it's used
- Class A wired fire alarm loops
- Sites requiring fault-tolerant detection circuits
- Hospitals, hotels & high-occupancy buildings
- Loops where a single short must not disable coverage
Technical Specifications
| Isolator Function | |
|---|---|
| Circuit Type | Class A fire alarm circuits |
| Fault Response Time | All isolators open within 23 msec of a short |
| Reclose Interval | 10 msec per isolator, from controller side inward |
| Recovery | Self-restoring, no manual reset required |
| Requires | Detector head installed to operate |
| Wiring | |
| Wire Sizes Accepted | #18, #16, #14, #12 AWG (0.75–2.5 mm²) |
| Preferred Wire | #16–#18 AWG for ease of installation |
| GSA-LED Support | Not supported on this base |
| Mounting | |
| North American Boxes | 1-gang, 3½" or 4" octagon, 4" square (1½" deep) |
| European Boxes | BESA and single-gang, 60.3mm fixing centers |
| Brand | |
| Manufacturer | Kidde — Model KI-IB |
4" variant with trim skirt (KI-IB4) also available. Ask us for the manufacturer datasheet.
Key Features
Fast Fault Isolation
Opens every isolator on the circuit within 23 milliseconds of a short.
Keeps the Loop Alive
Only the faulty section drops out — the rest of the circuit stays reporting.
Self-Restoring
No manual reset needed once the short is cleared — the loop recovers on its own.
Class A Compliant
Built specifically for Class A circuit wiring topology.
Wide Box Compatibility
Fits standard North American and European electrical box formats.
Flexible Wire Sizing
Accepts #18 AWG through #12 AWG wire for varied installation needs.
Product Documents
Download product information, installation guidance and technical documentation for the Kidde KI-IB Detector Base with Fault Isolator.
Product Data Sheet
Technical specifications, fault-isolation operation, wiring and mounting information.
View / Download PDFQuick Start Guide
Mounting, Class A wiring, detector installation and commissioning reference.
View / Download PDFUser Manual
Detailed operation, fault isolation sequence, wiring, maintenance and troubleshooting.
View / Download PDFNeed a document that isn't listed? Ask us and we'll send it over.
Need this for a project?
Send us your BOQ or drawings — we'll quote the full system, not just the device.